Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Transmission Details: Outboard
Condition: Extremely Tidy
Engine Hours: 120
Engine Details: Mercury 200hp Verado XL
EXTREMELY TIDY 2006 MERCURY 200HP VERADO XL (25 inch ) SHAFT OUTBOARD WITH ONLY 550 HOURS.
$2,850
Only logged in customers who have purchased this product may leave a review.
2003 SUZUKI 140hp EFI four stroke outboard motor model number DF140 standard 25″ shaft length.
Motor has power tilt and trim standard right hand rotation
This motor is good condition and not have any problem
Hour for this motor is 660 hrs
This motor included prop and control
2002 Nissan 70hp outboard motor. Standard 20” shaft length with power tilt and trim and desirable oil injection. Last of the super reliable, simple and light weight 2 stroke motor.
This is a reliable made in Japan Nissan power for little money. Basically same reliability and design of the Yamaha 70hp of its time without the Yamaha pricing.
Motor runs strong with 125lbs compression on all 3 cylinders. Tilt and trim works fine and lower unit is free of water and metal shavings. This is a nice used motor which should serve it next owner well if properly cared for.
1997 Yamaha 40 HP 2 Stroke Outboard Motor
20 “ shaft
Compression 135 PSI each cylinder
Motor has Approximately 500 Hours of Use (Mainly Freshwater)
Power Trim and Tilt
Carbureted /2 stroke
Cosmetically in Very Good Condition
Great Running Condition
Motor fully serviced prior to delivery
Prop and Controls is included
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us
There are no reviews yet.