Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
Yamaha 40hp 40VMHO short shaft outboard engine
Yamaha 40hp outboard engine 40VMHO short shaft – just run in! With 20L tank and fuel line. This has been a spare engine for our fleet of tiller boats (RYA training centre and rescue boat operator training provider).
Very Low hours (approx 10), removable prop guard, and very good condition prop. Comes with 20L plastic tank and fuel line and manual.
$1,550
Only logged in customers who have purchased this product may leave a review.
THIS IS A 6 CYL, DIRECT FUEL INJECTED ,TWO STROKE OIL INJECTED OUTBOARD WITH POWER TRIM AND TILT. THESE 6 CYLINDER HPDI YAMAHA MOTORS PRODUCE OUTSTANDING POWER AND RAW TORQUE. THEY ARE LIGHTER THEN A COMPARABLE FOUR STROKE AND THEY ARE MUCH STRONGER OUT OF THE HOLE.
THE MOTOR WAS LIGHTLY USED AND IT CLEAR WHEN YOU LOOK AT IT. THE COMPUTER SHOWED ONLY 239 TOTAL HOURS
MECHANICALLY THE MOTOR IS IN GREAT SHAPE. COMPRESSION WAS 120-125 PER CYLINDER. IT FIRES RIGHT UP, PUMPS GOOD WATER , SHIFTS SMOOTH AND SOUNDS EXCELLENT WHEN YOU RAP THE THROTTLE.
2002 Yamaha 250HP outboard motor 250TXRA 25″ OX66 Excellent condition
Good running take off
compression 120 120 120 125 125 125,
1300 hours on the motor
Rotation: Standard Rotation
Prop , Controls and rigging is included
Motor runs perfect
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
2002 Nissan 70hp outboard motor. Standard 20” shaft length with power tilt and trim and desirable oil injection. Last of the super reliable, simple and light weight 2 stroke motor.
This is a reliable made in Japan Nissan power for little money. Basically same reliability and design of the Yamaha 70hp of its time without the Yamaha pricing.
Motor runs strong with 125lbs compression on all 3 cylinders. Tilt and trim works fine and lower unit is free of water and metal shavings. This is a nice used motor which should serve it next owner well if properly cared for.
WhatsApp us
There are no reviews yet.