Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
2002 Mercury 250hp EFI outboard motor model 250XXL 30” inch long shaft motor has power tilt and trim and is also oil injected.
Compression reading of 115lbs compression which is perfect for this model. The tilt and trim works fine and lower unit is free of water or metal contamination.
Mercury controls and a stainless steel prop is included
$2,100
Only logged in customers who have purchased this product may leave a review.
2000 Honda 90HP 4 Stroke Outboard Engine
Motor has been Fully Serviced: new water pump ,gear lube, lower unit pressure tested all good, new thermostat, zincs, spark plugs , new oil filter , and new fuel filter.
The Outboard engine comes with controls, gauges, wiring harness and propeller.
Buy with confidence all our used engines are inspected/ serviced by qualified marine technicians and ready to mount and run with a three month mechanical warranty.
This here is a 2001 yamaha 225 hp 25″ shaft. It’s was tested before removal and its in good working condition.
This motor runs good.
The power tilt and trim works great and the lowerunit shifts in and out of gear smoothly
This motor included prop and control
HIS IS A 6 CYL, 2.5 LITER, CARBURETED OUTBOARD WITH POWER TRIM AND TILT. THESE MERCURY 150 OUTBOARDS PRODUCE OUTSTANDING POWER AND ARE BOTH SUPER RELIABLE AND VERY DURABLE. THIER LOW END TORQUE IS SECOND TO NONE.
MECHANICALLY YOU COULDN’T ASK FOR MORE. THE COMPRESSION WAS 115-120 ON ALL CYLINDERS. IT FIRES RIGHT UP, PUMPS GOOD WATER, SHIFTS SMOOTH AND SOUNDS EXCELLENT WHEN YOU RAP THE THROTTLE.
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us

There are no reviews yet.