Based on 0 reviews
Only logged in customers who have purchased this product may leave a review.
YAMAHA 70 HP Automix
2-stroke, 3-cylinder, L-shaft, Automix, power trim
Compressions: 9.0-9.0-9.0 Bar
Mint condition, fully serviced in “peace of mind” style and ready for action!
Included: brand new 703 RC box, shift/throttle cables according to your required length
$1,500
Only logged in customers who have purchased this product may leave a review.
2003 SUZUKI 140hp EFI four stroke outboard motor model number DF140 standard 25″ shaft length.
Motor has power tilt and trim standard right hand rotation
This motor is good condition and not have any problem
Hour for this motor is 660 hrs
This motor included prop and control
THIS IS A 6 CYL, DIRECT FUEL INJECTED ,TWO STROKE OIL INJECTED OUTBOARD WITH POWER TRIM AND TILT. THESE 6 CYLINDER HPDI YAMAHA MOTORS PRODUCE OUTSTANDING POWER AND RAW TORQUE. THEY ARE LIGHTER THEN A COMPARABLE FOUR STROKE AND THEY ARE MUCH STRONGER OUT OF THE HOLE.
THE MOTOR WAS LIGHTLY USED AND IT CLEAR WHEN YOU LOOK AT IT. THE COMPUTER SHOWED ONLY 239 TOTAL HOURS
MECHANICALLY THE MOTOR IS IN GREAT SHAPE. COMPRESSION WAS 120-125 PER CYLINDER. IT FIRES RIGHT UP, PUMPS GOOD WATER , SHIFTS SMOOTH AND SOUNDS EXCELLENT WHEN YOU RAP THE THROTTLE.
Clean Used 2002 Evinrude 200 HP V6 DFI 2 Stroke 20″ (Long Shaft) Outboard Motor. Model number: E200FPLSNF. Weight – 514 lbs. 130-135 psi compression on all 6 cylinders. Midsection has been replaced, so ID tag does not match the rest of the motor. New Impeller, Gear Oil, and Spark Plugs. Electric Start. Power Tilt/Trim.
2003 Suzuki 150hp, 25″ extra long, 2 stroke, oil injected, freshwater outboard
2003 Suzuki fuel injected, oil injected, 25″ or extra long, outboard motor. it is in very nice condition, there are no scratches and no sun fading. The way you see it is how clean it looked when we took it off the boat. Prop and control is included. We have done the following to this motor, we changed the oils and pressure and vacuum tested the lower unit, changed the water pump impeller, performed a leakdown test and all the cylinders were less than 3%. Ran and checked over the engine. The leakdown test is more accurate than a compression test, it has a gauge and you put air pressure in the spark plug hole and measure the percentage of air leaking past the piston and rings by rotating the flywheel. On this test 0% is the best 100% the worst, typically over 10-15% shows signs of wear and anything over 20% will start having a running issu
WhatsApp us
There are no reviews yet.